Mitsubishi Stealth 1994 Import Service Manual page 789

REAR SUSPENSION <AWD>
(2) Apply multipurpose grease to the lip and inside of the dust
(3) Wind tape around the threads of the stabilizer link stud and
(4) Secure the dust cover with the clip ring.
Clip ring ends
(Could be 180"
SERVICE POINTS OF INSTALLATION
6. INSTALLATION OF STABILIZER LINK / 2. SELF-
12AOll
cover.
Grease: MOPAR Multi-mileage Lubricant
Part No. 2525035 or equivalent
install the dust cover.
At this time, make sure that the clip ring ends are located at
a point 90" IL 20" with reference to the link axis.
LOCKING NUT / 1. SELF-LOCKING NUT
(1) Secure the stabilizer link ball stud with a wrench and
mount the self-locking nut.
(2) Hold the stabilizer link with a wrench so that its
protrusion on the lower arm side (dimension A) is up to
specification, then mount the self-locking nut.
Standard value: 5 - 7 mm (.I97 - .276 in.)