Mitsubishi Stealth 1994 Import Service Manual page 1190

Connection
Two wires
Insulation tape
Nuts
without wheel
SRS - Air Ban Module DisDosal Procedures
<Driver's side>
2. Connect two wires each six meters (20 feet) long or
3. Install a disused nut to each of the four bolts on the
4. Pass SRS air bag adapter harness B, connected with
5. Put the air bag module in the wheel fitted with a used
6. Stuck three used tires without wheel on the tire to
Caution
The air bag module should be stored on a flat ;L) ~
surface and placed so that the pad cover face up. Do
not place anything on top of it.
more, to the two leads of SRS AIR BAG ADAPTER
HARNESS B, and cover the connections with insulation
tape. The other ends of the two wires should be
connected to each other (short-circuited), to prevent
sudden unexpected deployment of the air bag.
front of air bag module and connect thick wires to these
bolts to secure the module to the wheel.
wires, under the used tire wheel assembly and connect
the harness to the air bag module.
tire. Using the wires or the like connected to the
module's bolts, secure the air bag module. Then turn
the module upward.
Caution
Slacken the adapter harness under the wheel to
allow for the reaction produced in deployment of
the module. If not, the adapter harness may be
damaged by the reaction created in deployment.
which the air bag module has been secured.