Mitsubishi Stealth 1994 Import Service Manual page 770

REAR SUSPENSION <FWD>
Lower bushing inner pipe '
SERVICE POINT OF DISASSEMBLY
1. REMOVAL OF PISTON ROD TIGHTENING NUT
press the coil spring using the special tool.
(2) While holding the piston rod, remove the piston rod
tightening nut.
INSPECTION
Check the rubber parts for damage.
l
Check the coil springs for crack, damage or deterioration.
l
SERVICE POINTS OF REASSEMBLY
11. INSTALLATION OF COIL SPRING
compress the coil spring and insert it in the shock
absorber.
(2) Align the edge of the coil spring to the position of the
shock absorber spring seat as shown.
seat
4. INSTALLATION OF BRACKET ASSEMBLY / 1. PISTON
ROD TIGHTENING NUT
the figure, tighten the tightening nut to the specified
torque.
(2) Install the coil spring so that the lower edge fits into the
spring seat groove and the upper edge fits into the
spring pad groove, then remove the special tools
(MB991 237, MB991 239).