Mitsubishi Stealth 1994 Import Service Manual page 1188

Insulation
M B686560
harness connector
SRS
3. Disconnect the clock spring connector from the SRS
4. Connect two wires each six meters (20 feet) long or
5. Connect the SRS AIR BAG ADAPTER HARNESS A to
<Passenger's side>
1. Remove the grove box and glove box outer case.
2. Disconnect the passenger's air bag module 2 pin
3. Connect two wires each six meters (20 feet) long or
diagnosis unit while pressing down the lock of the
connector. (Refer to P.23B-9.)
more, to the two leads of SRS AIR BAG ADAPTER
HARNESS A and cover the connections with insulation
tape. The other ends of the two wires should be
connected to each other (short-circuited), to prevent
sudden unexpected deployment of the air bag.
the clock spring connector (which has been discon-
nected from the SRS diagnosis unit), and then lead the
two connected wires outside the vehicle.
connector (red) from the body wiring harness connec-
tor.
NOTE
If the passenger's air bag module connector is discon-
nected from the body wiring harness, both electrodes
of the passenger's air bag module connector will be
automatically shorted to prevent unintended deploy-
ment of the air bag due to static electricity,etc.
more, to the two leads of SRS AIR BAG ADAPTER
HARNESS A and cover the connections with insulation
tape. The other ends of the two wires should be
connected to each other (short-circuited), to prevent
sudden unexpected deployment of the air bag.