Mitsubishi Stealth 1994 Import Service Manual page 753

PROPELLER SHAFT AND UNIVERSAL JOINTS
Inner race
Cage
commercially avail
(2) Put mating marks on the outer race, cage and inner race
with a scriber before removing the outer race and balls.
Caution
Note the positions of balls so that they can be
reinstalled in their original positions.
(3) Remove the inner race with cage from the center
propeller shaft by using a puller (commercially avail-
able).
NOTE
When changing the grease on the Lobro joint assembly,
wipe off the grease and clean the outer and inner races,
cage and balls.
(4) If the outer race cannot be removed, remove the
complete Lobro joint assembly from the center pro-
peller shaft by using a puller (commercially available).
Tape the serration of the center propeller shaft and then
remove the Lobro joint boot.
14. REMOVAL OF COMPANION FLANGE
Put mating marks on the companion flange and the rear
propeller shaft before removing the companion flange.
16-9