Mitsubishi Stealth 1994 Import Service Manual page 958

21-118
Steering lock assembly
AUTOMATIC TRANSAXLE
INSPECTION
Check the control cable for function and for damage.
l
l
l
REVERSE (R) POSITION ALARM BUZZER
Check that the buzzer sounds when battery voltage is applied
across terminals.
SERVICE POINTS OF INSTALLATION
23. CONNECTION OF SHIFT LOCK CABLE (BRAKE PEDAL
19. INSTALLATION OF SLIDE LEVER / 18. KEY INTERLOCK
6. CONNECTION OF TRANSAXLE CONTROL CABLE
4. CONNECTION OF SHIFT LOCK CABLE (SELECTOR LEV-
Check the outer cable (key interlock cable, shift lock cable)
for damage and spring for breakage and tension.
Check the inner cable (key interlock cable, shift lock cable)'&
for extension.
SIDE)
Connect the shift lock cable so that its threads measure
about 4 mm (.I6 in.).
Caution
Do not change the routing of shift lock cable to the
selector lever assembly.
CABLE (STEERING LOCK ASSEMBLY SIDE) / 17. CAM
LEVER
removed.
(2) Install the slide lever, key interlock cable, and cam lever
to the steering lock assembly as shown.
Caution
Do not change the routing of key interlock cable to
the selector lever assembly.
(SELECTOR LEVER ASSEMBLY SIDE)
Connect the transaxle control cable, then make the follow-
ing adjustment.
(2) Loosen the nut and slightly pull the transaxle control
cable in the direction of the arrow; then, tighten the nut.
ER ASSEMBLY SIDE)
(2) Disconnect the key interlock cable from the selector
lever assembly side.
(3) Turn the lock cam B counterclockwise (arrow 0) to
move the set lever upward (arrow 0).
(4) Fit the cutout in set lever to the lock pin of lock cam B. 'd