Mitsubishi Stealth 1994 Import Service Manual page 382

9-84
, Push in by the piston.
Piston
Piston rin$
ring gap
ENGINE - Piston and Connectinrr Rod
INSPECTION
PISTON RING
groove. When it exceeds the limit, replace the rings, the
piston, or both.
Standard value:
Limit: No.1
(2) Insert the piston ring into the cylinder bore putting it against
the top of the piston head and pressing it in.
When it makes a right angle, measure the piston ring gap
with a feeler gauge. When the gap is too large, replace the
piston ring.
Standard value:
Limit: No.1
BEARING
Measure the inner diameter of the connecting rod bearing and
the outer diameter of the crankshaft pin. If the oil clearance
exceeds the limit, replace the bearing, and crankshaft if
necessary.
Standard value:
<SOHC>
<DOHC>
Limit: 0.1 mm (.004 in.)
No.1 0.03 - 0.07 mm (.0012 - .0028 in.)
No.2 0.02 - 0.06 mm (.OOOS - .0024 in.)
No.2
No.1
No.2 0.45 - 0.60 mm (.0177 - .0236 in.)
Oil ring side rail
No.2
Oil ring side rail
0.016 - 0.046 mm (.0006 - .0018 in.)
0.022 - 0.048 mm (.0009 - .0019 in.)
0.1 mm (.004 in.)
0.1 mm (.004 in.)
0.20 - 0.60 mm
0.8 mm (.031 in.)
0.8 mm (.031 in.)