Mitsubishi Stealth 1994 Import Service Manual page 1176

SRS
SERVICE POINT OF INSTALLATION
PRE-INSTALLATION INSPECTION
(1) Before any front impact sensor is installed in the vehicle, it
must be visually inspected. If a dent, crack or other
deformation, or rust, is detected, discard the sensor and'
replace it with a new one that passes the visual inspection.
(2) Before any front impact sensor is installed in the vehicle,
the resistance between its terminals must be confirmed to
be within the standard value.
Standard value: 2,000 k 400
Use the digital multi meter. If the resistance is not within
that standard value range, discard it and replace it with a
new one that has the standard value.
3. INSTALLATION OF FRONT IMPACT SENSOR
there is no slack), and clip securely by using the clip of
the front impact sensor.
(2) Install the front impact sensor so that there is close
adherence of the upper surface of the front impact,
sensor and the installation surface of the upper frame Ll
(lower).
Caution
The SRS may not activate properly if a front impact
sensor is not installed properly, which could result
in the SRS system not operating properly during a
collision.
POST-INSTALLATION INSPECTION
Reconnect the negative battery terminal. Turn the ignition
switch to "ON". Check if the SRS warning light illuminates for
about 7 seconds and then remain OFF for at least 45 seconds.
If yes, SRS system is functioning properly. If no, cunsult page