Mitsubishi Stealth 1994 Import Service Manual page 1167

TEST 12 WHEN DIAGNOSTIC TROUBLE CODE No. 43 IS DISPLAYED
FUSIBLE LINK&?) IGNITION SW!TCH(IGl)
I
Insulating tape Battery (-) cable
SRS - Troubleshooting
(MULTI-PUROSE
COMBINATION METER
MALFUNCTION DETECTION CIRCUIT
20
. .
5
the negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the battery
cable before doing any further work. The SRS system is
designed to retain enough voltage to deploy the air bag
even after the battery has been disconnected. Serious
injury may result from unintended air bag deployment
if work is done on the SRS system immediately after
the battery cable is disconnected.
(2) Remove the rear console assembly. (Refer to GROUP 23A
Floor Console.)
(3) Apply a flat tip screwdriver to the lock spring (metallic
portion) of the SDU connector lock lever as illustrated and
push it horizontally toward the back of the unit.
Caution
1. Do not push up the lock lever (green) by force.
2. Never insert a screwdriver between the lock lever
(green) and the lock spring (metallic portion).
(4) Disconnect the red 14-pin connector from the SDU.
SRS diagnosis unit
View A
Unused terminals
To clock spring
To body wiring harness (14-pin)