Mitsubishi Stealth 1994 Import Service Manual page 802

STEERING
pulley
Extension bar
running stopped
Return ho
<SOHC Engine>
1. Press in drive belt at the illustrated position with about 100
N (22 Ibs.) and measure deflection.
Brace bolt
S t a n d a r d v a l u e
pulley nut
When belt tension is inspected
When new belt is installed
2. If the deflection is out of the standard values, loosen the
tension pulley nut and adjust the belt tension with brace
bolt.
<DOHC Engine>
1. Press in drive belt at the illustrated position with about 100
N (22 Ibs.) and measure deflection.
Standard value
When belt tension is inspected
2. If the deflection is out of the standard values, adjust the belt
tension using the following procedure.
(2) Mount the extension bar on the tension pulley.
(3) While increasing the tension of the drive belt with the
FLUID LEVEL CHECK
1. Park the vehicle on a flat, level surface, start the engine, and
then turn the steering wheel several times to raise the
temperature of the fluid to approximately 50 - 60°C (122 -
2. With the engine running, turn the wheel all the way to the
left and right several times.
3. Check the fluid in the oil reservoir for foaming or milkiness.
Check the difference of the fluid level when the engine is
stopped, and while it is running. If the fluid level changes
considerably, air bleeding should be done.
FLUID REPLACEMENT
1. Raise the front wheels on a jack, and then support them
with rigid racks.
2. Disconnect the return hose connection.
3. Connect a vinyl hose to the return hose, and drain the oil
into a container.
Vinyl hose
extension bar, retighten the tension pulley's securing d
bolts A and B in the order mentioned.
6.0 - 9.0 mm (.24- .35 in.)
I 7.5-9.0 mm (.30-.35 in.)
I