Mitsubishi Stealth 1994 Import Service Manual page 1157

CONTINUED FROM PREVIOUS PAGE
Is the SRS warning light operation
normal?
Yes
I
CONTINUED ON NEXT PAGE
SRS
ignition key to the "ON" position.
(2) Using the scan tool, erase the diagnostic trouble code
memory. (Refer to TEST 1.)
(3) Return the ignition key from the "ON" to the "LOCK"
position and then back to the "ON" position.
,
nect
the negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the
battery cable before doing any further work. The
deploy the air bag even after the battery has been
disconnected. Serious injury may result from unin-
tended air bag deployment if work is done on the
SRS system immediately after the battery cable is
disconnected.
(2) Apply a flat tip screwdriver to the lock spring (metallic
portion) of the SDU connector lock lever as illustrated
and push it horizontally toward the back of the unit.
Caution
1. Do not push up the lock lever (green) by force.
2. Never insert a screwdriver between the lock
lever (green) and the lock spring (metallic por-
tion).
(3) Disconnect the red 2-pin connector of the SRS Check
Harness from the SDU.
,
,
,