Dtc P0113 Intake Air Temperature Sensor Circuit High - Suzuki Wagon R Plus RB310 Service Manual

DTC P0113 Intake Air Temperature Sensor Circuit High

Wiring Diagram
1
E23
7 6 5 4 3
17 16 15 14 13 12 11
27 26 25 24 23 22 21
34 33 32 31
1. MAF and IAT sensor
2. ECM
DTC Detecting Condition and Trouble Area
DTC Detecting Condition
DTC will be set when all of the following conditions are
detected for 0.5 seconds continuously.
• Engine is running
• Voltage of IAT sensor output is more than the specified
value
(Low intake air temperature (high voltage/high resistance))
DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC using scan tool.
3) Start engine and run it for 10 sec.
4) Check DTC and pending DTC.
Troubleshooting
Step
1 Was "Engine and Emission Control System
Check" performed?
4
BLK/RED
WHT
RED
LT GRN
BRN/WHT
E22
2 1 7 6 5 4 3
10 9 8 19 18 17 16 15 14 13 12 11
20 19 18 27 26 25 24 23
30 29 28 35 34 33 32 31
3. To other sensor
4. From main relay
Action
ENGINE GENERAL INFORMATION AND DIAGNOSIS (M13 ENGINE) 6-2-73
2
E22-14
E22-32
E22-17
BRN/WHT E22-28
3
E21
2 1 6 5 4 3 2
10 9 8 16 15 14 13 12 11 10 9 8
22 21 20 27 26 25 24 23 22 21 20 19
30 29 28 35 34 33 32 31 30
• IAT sensor circuit
• IAT sensor
• ECM
Yes
Go to Step 2.
1
7
18 17
29 28
Trouble Area
Go to "Engine and Emis-
sion Control System
Check" in this section.
No