Table of Contents
Advertisement
WATER PUMP
E
WATER PUMP
REMOVAL
I
INSTALLATION
Caution
• Do not disassemble the water pump. If a problem is found, replace the pump as a unit.
• After radiator cowling installation, rotate the cooling fan by hand and verify that the fan blade
does not touch the radiator cowling.
If the fan touches the cowling, adjust the radiator cowling mounting position.
1. Disconnect the negative battery cable.
2. Drain the engine coolant.
3. Remove in the order shown in the figure.
4. Install in the reverse order of removal.
Steps After Installation
1. Fill the radiator with the specified amount and type of engine coolant. (Refer to page E-7.)
2. Connect the negative battery cable.
3. Start the engine and check for leaks.
19-25
(1.9-2.6,
14-19)
CD
9TFOEX.o10
1 . Radiator cowling
4. Water pump pulley
2. Water pump drive belt
5. Water pump
Adjustment .................................... Section B
3. Cooling fan
Inspect for cracked and damaged mount-
ing surface, bearing condition, and leakage
E-11
Advertisement
Table of Contents
Troubleshooting
