Pptp Server Commands; Vpn Pptp Server Configure - NETGEAR ProSafe SRX5308 Cli Reference Manual

Related show command:

PPTP Server Commands

vpn pptp server configure

This command configures the PPTP server. After you have issued the vpn pptp server
configure command, you enter the pptp-server-config [policy] mode, and then you can
configure one keyword and associated parameter or associated keyword at a time in the
order that you prefer.
Step 1 Format
Mode
Step 2 Format
Mode
Keyword
enable
start_address
end_address
idle_timeout
Command example:
SRX5308> vpn pptp server configure
pptp-server-config[policy]> enable Y
pptp-server-config[policy]> start_address 192.168.112.1
pptp-server-config[policy]> end_address 192.168.112.25
pptp-server-config[policy]> idle_timeout 10
pptp-server-config[policy]> save
Related show command:
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
show vpn ipsec radius [ipaddress]
vpn pptp server configure
vpn
enable {Y | N}
start_address <ipaddress>
end_address <ipaddress>
idle_timeout <minutes>
pptp-server-config [policy]
Associated Keyword to
Select or Parameter to Type
Y or N
ipaddress
ipaddress
minutes
show vpn pptp server setup
VPN Mode Configuration Commands
Description
Enables or disables the PPTP server.
The start IPv4 address of the PPTP server range.
The end IPv4 address of the PPTP server range.
The idle time-out after which the connection is terminated.
and show vpn pptp server connections
265