Configuring Mode Config Operation On The Vpn Firewall - NETGEAR FVS336Gv1 - ProSafe Dual WAN Gigabit Firewall Reference Manual

ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336G Reference Manual
IP address from the configured IP address pool and activates a temporary IPsec policy, using the
information that is specified in the Traffic Tunnel Security Level section of the Mode Config
record (on the Add Mode Config Record screen that is shown in
Note: After configuring a Mode Config record, you must manually configure an IKE
policy and select the newly-created Mode Config record from the Select Mode
Config Record pull-down menu (see
VPN Firewall." You do not need to make changes to any VPN policy.
Note: An IP address that is allocated to a VPN client is released only after the VPN client
has gracefully disconnected or after the SA liftetime for the connection has timed
out.

Configuring Mode Config Operation on the VPN Firewall

You need to configure two screens to configure Mode Config operation on the VPN firewall: the
Mode Config screen and the IKE Policies screen.
Configuring the Mode Config Screen
To configure the Mode Config screen:
1. Select VPN > IPsec VPN from the menu.
2. Click the Mode Config tab. The Mode Config screen is displayed.
Figure 5-24
Virtual Private Networking Using IPsec
"Configuring Mode Config Operation on the
v1.0, January 2010
Figure 5-25 on page 5-26).
5-25