Ipv4 Wan Commands - NETGEAR ProSafe FVS318N Cli Reference Manual

Related show command:

IPv4 WAN Commands

net wan_settings wanmode configure
This command configures the mode of IPv4 routing between the WAN interface and LAN
interfaces. After you have issued the net wan_settings wanmode configure
command, you enter the net-config [routing-mode] mode, and then you can configure NAT or
classical routing.
WARNING!
Changing the mode of IPv4 routing causes all LAN–WAN and
DMZ–WAN inbound firewall settings to revert to default settings.
Step 1 Format
Mode
Step 2 Format
Mode
Related show command:
net wan wan1 ipv4 configure
This command configures the IPv4 settings of the WAN interface. After you have issued the
net wan wan1 ipv4 configure command, you enter the net-config [wan1-ipv4] mode.
First, specify the ISP connection type (you can select only a single type). Then, for the
selected ISP connection type, configure one keyword and associated parameter or
associated keyword at a time in the order that you prefer. If you select a static ISP connection
type, there is no further configuration required.
Step 1 Format
Mode
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
show net wan port_setup
net wan_settings wanmode configure
net
type {NAT | Classical_Routing}
net-config [routing-mode]
show net wan_settings wanmode
net wan wan1 ipv4 configure
net
Net Mode Configuration Commands
30