Avaya DEFINITY Server CSI Maintenance Manual page 1640

Maintenance Objects
Table 478. TEST #1242 Level 1 Status Inquiry — Continued
Error Test
Code Result
2000 ABORT
2012 ABORT
2100 ABORT
1 FAIL
2 FAIL
1640
Issue 5 October 2002
Description/ Recommendation
Response to the test was not received from the circuit pack within the
allowable time period.
1. If the test aborts repeatedly a maximum of 5 times, reset the circuit
pack with the busyout board PCSS and reset board PCSS
commands.
2. If the test aborts again, replace the circuit pack.
Internal system error
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Received a status of Level 1 Pending Activation. U interface down
indicating a problem with a connection between the switch and the NT1, a
2- to 4-wire converter that is used to connect 4-wire terminals to a 2-wire
TN2198 or TN2185 circuit pack.
1. Verify that the connections between the switch and the NT1 are good.
Verify that the NT1 has power.
2. Execute the test port PCSSpp command and review the results of the
Level 1 Status Inquiry Test to verify the repair. If this test still fails,
proceed to Step 3.
3. Follow the manufacturers repair procedures for the NT1. Then execute
the test port PCSSpp command and review the results of the Level 1
Status Inquiry Test to verify repair.
Received a status of Level 1 Pending Activation. U interface up, S/T
interface down, which indicates a problem with the NT1 or the wiring
between the NT1 and the BRI endpoint (S/T interface).
1. Execute the test port PCSSpp command and review the results of the
Level 1 Status Inquiry test to verify the repair. If this test still fails,
proceed to Step 2.
2. Follow the manufacturer-recommended repair procedures for the NT1.
Then execute the test port PCSSpp command and review the results
of the Level 1 Status Inquiry test to verify repair.
Continued on next page