Extreme Networks ExtremeWare XOS Command Reference Manual page 1066

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Network Login Commands
10 Gigabit Ethernet ports such as those on the 10G4X I/O module and the uplink ports on the
●
Summit X450 family of switches do not support netlogin MAC-based VLANs.
If you attempt to configure netlogin MAC-based VLANs on 10 Gigabit Ethernet ports, the switch
displays an error message similar to the following:
ERROR: The following ports do not support the MAC-Based VLAN mode; 1, 2, 10
You can have a maximum of 1,024 MAC addresses per I/O module or per Summit X450 family
●
switch.
Displaying FDB Information. To view netlogin-related FDB entries, use the following command:
show fdb netlogin [all | mac-based-vlans]
The following is sample output from the
Mac
------------------------------------------------------------------------
00:04:96:10:51:80
00:04:96:10:51:81
00:04:96:10:51:91
00:04:96:10:51:11
00:04:96:10:51:31
Flags : d - Dynamic, s - Static, p - Permanent, n - NetLogin, m - MAC, i - IP,
x - IPX, l - lockdown MAC, M - Mirror, B - Egress Blackhole,
b - Ingress Blackhole, v - NetLogin MAC-Based VLAN.
The flags associated with netlogin include:
—Indicates the FDB entry was added because the port is part of a MAC-Based virtual port/VLAN
●
v
combination.
—Indicates the FDB entry was added by network login.
●
n
Displaying Port and VLAN Information. To view information about the VLANs that are temporarily added
in MAC-based mode for netlogin, use the following command
show ports <port_list> information detail
The following is sample output from this command:
Port: 1
Virtual-router: VR-Default
Type:
Random Early drop:
Admin state:
Link State:
Link Counter: Up
VLAN cfg:
Name: Default, Internal Tag = 1(MAC-Based), MAC-limit = No-limit
...<truncated output>
Egress 802.1p Replacement:
NetLogin:
NetLogin authentication mode:
NetLogin port mode:
Smart redundancy:
1066
show fdb mac-based-vlans
Vlan Age
VLONE(0021) 0086
VLTWO(0051) 0100
VLTWO(0051) 0100
VLTWO(0051) 0100
VLTEN(0051) 0100
UTP
Disabled
Enabled with auto-speed sensing
Active, 100Mbps, full-duplex
1 time(s)
Disabled
Enabled
Mac based
MAC based VLANs
Enabled
command:
Use Flags Port List
0000 n m v 1:11
0000 n m v 1:11
0000 n m v 1:11
0000 n m 8:1
0000 d m 8:10
auto-duplex
ExtremeWare XOS 11.5 Command Reference Guide