Fusing Fan Motor Removal; Transfer Belt Fan Motor Removal - Epson ACULASER COLOR 2000 Service Manual

EPSON AcuLaser C2000 / AcuLaser C1000

4.2.11.2 Fusing Fan Motor Removal

1. Remove the Rear Controller Cover. (See "Rear Controller Cover Removal"
on page -145.)
2. Free the fusing fan motor harness from 4 harness clamps.
3. Disconnect 1 fusing fan motor connector and remove 2 long screws
securing the Fusing Fan Motor, and remove the Fusing Fan Motor.
Figure 4-29. Fusing Fan Motor Removal
Disassembly and Assembly

4.2.11.3 Transfer Belt Fan Motor Removal

1. Remove the Rear Controller Cover. (See "Rear Controller Cover Removal"
on page -145.)
2. Remove the Rear Right Cover. (See "Rear Right Cover Removal" on
page -146.)
3. Remove the PU1 Support Board Removal. (See "PU1 Support Plate
Removal" on page -154.)
4. Free the toner sucking fan harness from 4 harness clamps.
5. Disconnect the connector for the toner sucking fan and remove 2 long
screws.
Figure 4-30. Transfer Belt Fan Motor Removal
Disassembling Procedure
Revision E
156