Front / Rear Pe Sensor Removal - Epson Stylus 1500 Service Manual

Front / Rear PE Sensor Removal

1. Remove the upper housing. (See page 3-7.)
2. Remove the printer mechanism. (See page 3-9.)
3. Disconnect the sensor cables from the sensor connectors.
4. Remove the sensors from the rear paper guide assembly. (Release the hooks on both sides of
the sensors by inserting a screwdriver between the sensors and the rear paper guide assembly
as shown in the figure below.)
Front PE Sensor Cable
Figure 3-30. Removing the Front / Rear PE Sensors
EPSON Stylus 1500 Service Manual
Rear Paper Guide Assembly
Front PE Sensor Cable
Disassembly and Assembly
Rear PE Sensor Cable
Rear PE Sensor Cable
Hoo k s
3-33