Sib Leds; T4000 Connector Interface Panel (Cip) Overview; T4000 Connector Interface Panel (Cip) Description; T4000 Connector Interface Panel (Cip) Components - Juniper T4000 Hardware Manual

Related
Documentation

T4000 Connector Interface Panel (CIP) Overview

T4000 Connector Interface Panel (CIP) Description

Copyright © 2013, Juniper Networks, Inc.

SIB LEDs

Each SIB has two LEDs on the craft interface that indicate its status. The SIB LEDs, labeled
through , are located on the upper right of the craft interface. The
SIB0 SIB4
on the SIB faceplate is not replicated on the craft interface.
Table 8 on page 27 describes the functions of the SIB LEDs.

Table 8: SIB LEDs on the Craft Interface

Label Color
Red
FAIL
Green
OK
T4000 Craft Interface Description on page 23
T4000 LED Overview on page 190
T4000 Alarm Messages Overview on page 191
T4000 Connector Interface Panel (CIP) Description on page 27
T4000 Connector Interface Panel (CIP) LEDs on page 29
T4000 Connector Interface Panel (CIP) Components on page 27
Management Ports on page 28
T4000 Alarm Relay Contacts on page 29

T4000 Connector Interface Panel (CIP) Components

The Connector Interface Panel (CIP) consists of Ethernet, console, and auxiliary ports
for the Routing Engines and alarm relay contacts (see
located at the left side of the FPC card cage, above the front electrostatic discharge
point.
The CIP is hot-pluggable.
Chapter 3: T4000 Hardware Components Overview
State Description
On steadily SIB has failed.
On steadily SIB is functioning normally.
ACTIVE
Figure 15 on page 28). The CIP is
LED
27