Inserting Or Removing A Pc Card From An M320 Routing Engine; Inserting A Pc Card Into An M320 Routing Engine - Juniper M320 Hardware Manual

M320 Router Hardware Guide

Inserting or Removing a PC Card from an M320 Routing Engine

Inserting a PC Card into an M320 Routing Engine

170
The slots labeled
PC CARD
defined in the PC Card Standard published by the Personal Computer Memory Card
International Association (PCMCIA). The router is shipped with a PC Card that contains
the Junos OS. The PC Card can be used to copy Junos OS from the PC Card onto the
Routing Engine. You can also copy Junos OS from the Routing Engine onto a PC Card,
for example, to create a backup copy of upgrade software that you have obtained from
Juniper Networks. Instructions for copying software to a PC Card are available at the
Juniper Networks Support Web site (
navigate to the Customer Support Center, then to the download page for Junos OS.
NOTE: The software on a PC Card is loaded only onto the Routing Engine
into which the PC Card is inserted. It is not automatically copied to the other
Routing Engine.
Inserting a PC Card into an M320 Routing Engine on page 170
Removing an M320 PC Card on page 171
To insert a PC card (see Figure 87 on page 171):
Insert the PC card into either PC card slot on the Routing Engine, with the Juniper
1.
Networks logo facing downward.
CAUTION: Be sure to insert the PC card with the label facing downward.
Inserting the PC card incorrectly might damage the Routing Engine.
CAUTION: Do not install more than one PC card in the Routing Engine.
Press the card firmly all the way into the slot.
2.
To verify the PC card is installed correctly, check that the corresponding slot LED
3.
(labeled 0 or 1 SLOT ) is lit.
on the Routing Engine faceplate accept a Type I PC Card, as
http://www.juniper.net/support/
). After logging in,
Copyright © 2010, Juniper Networks, Inc.