Removing And Inserting The Pc Card; Removing The Pc Card; Figure 46: Installing A Routing Engine - Juniper M10i Hardware Manual

M10i Internet Router Hardware Guide

Figure 46: Installing a Routing Engine

Removing and Inserting the PC Card

The slot labeled
as defined in the PC Card Standard published by the Personal Computer Memory
Card International Association (PCMCIA). The router is shipped with a PC Card that
contains JUNOS Internet software. The PC card can be used to copy JUNOS software
from the PC Card onto the Routing Engine. You can also copy JUNOS software from
the Routing Engine onto a PC Card, for example, to create a backup copy of upgrade
software that you have obtained from Juniper Networks. Instructions for copying
software to a PC Card are available at the Juniper Networks Support Web site
(
Center, then to the download page for JUNOS Internet software.
NOTE: The appearance and position of electronic components or the PC card slot
on your Routing Engine might differ from the figures in this section. These differences
do not affect Routing Engine installation and removal or functionality.
NOTE: The software on a PCMCIA card is loaded only onto the Routing Engine into
which the PCMCIA card is inserted. It is not automatically copied to the other Routing
Engine.
To remove and insert a PC card, perform the following procedures:

Removing the PC Card

The PC card is inserted in the slot labeled
To remove the PC card, follow this procedure (see
1.
124
Replacing Routing Engine Components
on the Routing Engine faceplate accepts a Type I PC Card,
PC CARD
http://www.juniper.net/support/
Removing the PC Card
Inserting the PC Card on page 125
Press the eject button located next to the PC card slot in the Routing Engine
faceplate. Note that the PC card slot might be located in a different position from
that shown in
Figure 47
); after logging in, navigate to the Customer Support
on page 124
in the Routing Engine faceplate.
PC CARD
Figure 47
.
):