Omron OMNUC W Series User Manual page 401

Appendix
Parameter Parameter
Para- Para-
name name
meter meter
Digit
No. No.
No.
Pn512 Output 0
signal
reverse reverse
1
2
3
Pn51A Position er- Sets the allowable error for a full closed-loop or
ror over- semiclosed-loop encoder
flow level
between
motor and
load
Note 1. Explanation for parameters set using 5 digits.
Note 2. Explanation for parameters requiring each digit No. to be set separately.
H Other Parameters (From 600)
Parameter Parameter
No. name
Pn600 Regeneration
resistor ca-
pacity
Pn601 Not used.
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Explanation (See note 1.)
Name Set- Explanation (See note 2.)
ting
Output
0 Not reversed.
signal
reverse reverse
for CN1
1 Reversed.
pins 25,
26
Output
0 Not reversed.
signal
reverse reverse
for CN1
1 Reversed.
pins 27,
28
Output
0 Not reversed.
signal
reverse reverse
1 Reversed.
CN1 pins
29, 30
Not used. 0 (Do not change setting.)
Explanation
Setting for regeneration resistor load ratio
monitoring calculations
(Do not change setting.)
Default Default Default Default Unit Unit
setting setting setting setting
100/200 V 100/200 V 400 V 400 V
0000 0000 ---
0 Comma 0 to
nd unit 32767
Default Unit
setting
0 x 10 W From 0
(varies by
Unit.)
0 --- ---
Chapter 6
Setting Setting Restart Restart
range range power? power?
--- Yes
--- ---
Setting Restart
range power?
---
---
6-21