Omron OMNUC W Series User Manual page 231

Operation
Note 1. There is no right shift function for the front panel keys.
Note 2. Press the DATA Key on the front panel for less than 1 s. Pressing the Key for 1 s or more
causes the Unit to recognize the Key as the DATA Key.
• The function code, parameter number, and monitor number are the rightmost three digits of the digits
that can be changed. Press the Left Key (front panel: DATA Key for less than 1 s) to change the op-
eration digit as follows:
Units (digit No. 0) to 10s (digit No. 1) to 100s (digit No. 2) to units (digit No. 0), etc.
Note This manual uses digit numbers shown above to denote the position of the digit in question in the
5-digit display. The rightmost digit is digit No. 0, and the leftmost digit is digit No. 4. Also, you can
change 4 or 5 digits in the parameter setting data. Press the Left Key (front panel: DATA Key for
less than 1 s) to shift the operation digit to the left in the same way. After you reach the leftmost
digit you can change, the display returns to digit No. 0.
• Use the following operation to shift the operation digit if, for example, you want to change the setting
from 00500 to 01000.
Select operation digit No. 2 using the Left Key (front panel: DATA Key for less than 1 s), and then
press the Up Key 5 times at digit No. 5. You can shorten the operation time by performing operations
in this way.
• You can shorten the operation time by using the operation digit shift function, but the digit number
from which you start the operation depends on which current setting (display contents) you want to
change. Try a variety of different procedures to find the best one.
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Less
than 1 s
Chapter 4
Less
than 1 s
4-15