Omron OMNUC W Series User Manual page 319

Operation
Note 2. A torque will be generated that accelerates the Servomotor in the forward direction if torque
feed-forward is applied with a positive (+) voltage. Be sure that the polarity is correct because
errors such as reverse Servomotor rotation or oscillation will occur if the feed-forward is ap-
plied with a polarity opposing the acceleration direction.
4-8-4 Speed Feed-forward Function (Position)
H Functions
• This function shortens positioning time by adding the REF (speed command input) value to the speed
loop.
• Normally, the differential value for the position command (pulse train command) is generated in the
controller, and input to REF.
• If the feed-forward amount (REF voltage) is too large, an overshoot may occur, so adjust Pn300
(speed command scale) as required.
Speed Feed-forward Function Block Diagram
Host Controller
Differ-
ential
Position command
H Parameters Requiring Settings
Parameter No.
Pn207.1 Speed command
input switching
Pn300 Speed command
scale
Note The default setting is 1000 (x 0.01 V / rated number of revolutions).
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Speed feed-forward
Command
pulses
Encoder output
Parameter
name
Set Pn207.1 to 1 (use REF as speed torque
feed-forward input).
Adjust the speed feed-forward amount. (See note.)
Servo Driver
Speed com-
mand scale
Deviation
Electronic gear
counter
ratio (G1/G2)
Encoder di-
viding rate
Explanation
Chapter 4
Current
Speed
loop
loop
Current
Speed
detection detection
Example
4-4-4 Parameter
Details e a s
4-103