Omron OMNUC W Series User Manual page 303

Operation
H Parameters Requiring Settings
Parameter Parameter name
No.
Pn207.0 Select position
control filter
Pn204 Position control
filter time constant
1 (primary filter)
Pn208 Position control
filter time constant
2 (linear
acceleration and
deceleration)
Note If not using the position command filter function, set each content to 0 (i.e., the default setting).
H Operation
• The characteristics for each filter are shown below.
• Servomotor acceleration and deceleration are delayed further than the characteristics shown below
due to position loop gain delay.
Acceleration: 2/Kp (s); Deceleration: 3/Kp (s); Kp: Position loop gain (Pn102)
D Primary filter
Command pulse in-
put frequency
Input frequency x 0.63
Input frequency x 0.37
D Linear acceleration and deceleration
Command pulse in-
put frequency
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Select either primary filter (setting: 0), or linear
acceleration and deceleration (setting: 1).
Enabled when Pn207.0 = 0. Be sure to set the
primary filter time constant (setting range = 0 to 6400
(x 0.01 ms)).
Enabled when Pn207.0 = 1. Be sure to set the
acceleration and deceleration times (setting range =
0 to 6400 (x 0.01 ms)).
Speed
Speed
Explanation
Chapter 4
Reference
4-4-4
Parameter a a e e
Details
Time
Time
4-87