Garp Timer Leave Command; Garp Timer Leaveall Command - ZyXEL Communications Multi-service Access Platform MSAP2000 User Manual

MSAP2000 AAMS User's Guide
This command sets the MSAP2000 AAMS's join period timer for GVRP in
milliseconds.
Switches join VLANs by making a declaration. A declaration is made by
issuing a Join message using GARP. GARP timers set declaration timeout
values.
The following example sets the Join Timer to 300 milliseconds.
Figure 114
ras> switch garptimer join 300

27.8.3 GARP Timer Leave Command

Syntax:
ras> switch garptimer leave <leave msec>
where
<leave msec>
This command sets the MSAP2000 AAMS's leave period timer for GVRP in
milliseconds.
Switches join VLANs by making a declaration. Declarations are withdrawn by
issuing a Leave message. GARP timers set declaration timeout values.
The following example sets the Leave Timer to 800 milliseconds.
Figure 115
ras> switch garptimer leave 800

27.8.4 GARP Timer Leaveall Command

Syntax:
ras> switch garptimer leaveall <leaveall msec>
GARP Timer Join Command Example
= This sets the duration of the Leave Period timer for
GVRP in milliseconds. Each port has a single Leave
Period timer. Leave Time must be two times larger
than Join Timer; the default is
600
milliseconds.
GARP Timer Leave Command Example
202