Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
13.2.1 Configure STP
Click Advanced Application and then Spanning Tree Protocol in the
navigation panel to display the STP status.
Click STP Config to display the Spanning Tree Protocol Configuration
screen as shown next.
Figure 47
The following table describes the labels in this screen.
Table 36
LABEL
STP Status
Active
Bridge Priority
Hello Time
Spanning Tree Protocol: Configuration
Spanning Tree Protocol: Configuration
DESCRIPTION
Click STP Status to display the MSAP2000 AAMS's STP status.
Select this check box to turn on RSTP.
Note: It is recommended that you only use STP when you use
the MSAP2000 AAMS in standalone mode with a
network topology that has loops.
Bridge priority is used in determining the root switch, root port and designated
port. The switch with the highest priority (lowest numeric value) becomes the
STP root switch. If all switches have the same priority, the switch with the
lowest MAC address will then become the root switch. The allowed range is 0
to 61440.
The lower the numeric value you assign, the higher the priority for this
bridge. Bridge Priority determines the root bridge, which in turn determines
Hello Time, Max Age and Forwarding Delay.
This is the time interval in seconds between BPDU (Bridge Protocol Data
Units) configuration message generations by the root switch. The allowed range
is 1 to 10 seconds.
104
Advertisement
Table of Contents
