Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
Figure 49
The following table describes the labels in this screen.
Table 37
LABEL
802.1x
Enable Server
IP address
UDP Port
Shared Secret
Apply
Enable Local
Profile Setting
Name
Password
Retype Password Type the password again to make sure you have entered it properly.
to confirm
Add
Port Authentication: RADIUS
Port Authentication: RADIUS
DESCRIPTION
Click 802.1x to configure individual port authentication settings.
Select this check box to have the MSAP2000 AAMS use an external RADIUS
server Authentication authenticate users.
Enter the IP address of the external RADIUS server in dotted decimal notation.
The default port of the RADIUS server for authentication is 1812. You need not
change this value unless your network administrator instructs you to do so.
Specify a password (up to 31 alphanumeric characters) as the key to be shared
between the external RADIUS server and MSAP2000 AAMS. This key is not sent
over the network and must be the same on the external RADIUS server and AAMS.
Click Apply to save your changes to the MSAP2000 AAMS's volatile memory.
The MSAP2000 AAMS loses these changes if it is turned off or loses power, so
use the Config Save link on the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Select this check box to have the AAM use its internal database of user names
and passwords to authenticate users.
Type the user name of the user profile. You can enter up to 31 ASCII characters;
spaces are not allowed.
Type a password for this user profile. You can enter up to 31 ASCII characters;
spaces are not allowed.
Click Add to save your changes to the MSAP2000 AAMS's volatile memory.
The MSAP2000 AAMS loses these changes if it is turned off or loses power, so
use the Config Save link on the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
107
Advertisement
Table of Contents
