Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
2 Wait for the Starting XMODEM upload message before activating XMODEM
upload on your terminal.
3 This is an example Xmodem configuration upload using HyperTerminal.
Click Transfer, then Send File to display the following screen.
Figure 152
4 After a successful configuration file upload, type atgo to restart the
MSAP2000 AAMS.
The MSAP2000 AAMS is now reinitialized with a default configuration file
including the default password of "1234".
32.13 Recovering the Firmware
Usually you should use the web configurator, FTP or console port to upload the
MSAP2000 AAMS's firmware. If the MSAP2000 AAMS will not start up, the
firmware may be lost or corrupted. Use the following procedure to upload
firmware to the MSAP2000 AAMS only when you are unable to use another
method to upload firmware.
Note: This procedure is for emergency situations only.
1 Obtain the firmware file, unzip it and save it in a folder on your computer.
2 Connect your computer to the console port and use terminal
emulation software configured to the following parameters:
•
VT100 terminal emulation
•
No parity, 8 data bits, 1 stop bit
3 Turn off the MSAP2000 and turn it back on to restart it and begin a session.
4 When you see the
message
5 Type
port speed to 115200 bps).
6 Change the configuration of your terminal emulation software to use
115200 bps and reconnect to the MSAP2000 AAMS.
Example Xmodem Upload
Press any key to enter Debug Mode within 3 seconds
press a key to enter debug mode.
,
after the
atba5
Enter Debug Mode
Type the configuration file's
location, or click Browse to
search for it.
Choose the 1K Xmodem
protocol
Then click send
•
115200 bps
•
No flow control
message (this changes the console
247
Advertisement
Table of Contents
