Table of Contents
Advertisement
2.1.1 Front Access Ports
The following wiring illustration describes how the POTS RJ45 port and LINE
RJ45 port match to the wiring post of a MSAP2000 FXS at the MSAP2000 system
backplane. MSAP2000 AAMS module provides up to 12 channels of ADSL+voice
service.
Each POTS RJ45 connector supports four FXS subscriber line. Connect the wiring
between FXS wiring post and the POTS connector so the voice traffic can be
combined with the ADSL traffic in the AAMS built-in splitter. The combined signal
will then come out from the LINE port. The combined signal will usually go to a
MDF.
Two RJ45-male-to-open wire cables will be used for every four subscribers. Each
AAMS will need six such cables. The length of the cable must be carefully
measued between the FXS wiring post and AAMS front panel, as well as between
AAMS front panel and the MDF.
FXS
1
2
3
4
5
6
7
8
POTS
1
2
3
4
5
6
7
8
LINE
25
Advertisement
Table of Contents
