Setting Up The Administrator Login Account - ZyXEL Communications Multi-service Access Platform MSAP2000 User Manual

MSAP2000 AAMS User's Guide
The following table describes the labels in this screen.
Table 46
LABEL
Return
Get Community
Set Community
Trap Community
Trap Destination
Port
Host
Apply
Cancel

18.3.5 Setting Up the Administrator Login Account

Click Advanced Application and Access Control from the navigation panel and
then Logins
from the Access Control screen to open the following screen.
Note: It is highly recommended that you change the default administrator
password
("1234").
Figure 58
Access Control: SNMP
DESCRIPTION
Click Return to go back to the previous screen.
Enter the get community, which is the password for the incoming Get- and
GetNext- requests from the management station. You can use up to 31
ASCII characters; spaces are not allowed.
Enter the set community, which is the password for incoming Set- requests
from the management station. You can use up to 31 ASCII characters;
spaces are not allowed.
Enter the trap community, which is the password sent with each trap to the SNMP
manager. You can use up to 31 ASCII characters; spaces are not allowed.
Enter the IP address of a station to send your SNMP traps to.
Enter the port number upon which the station listens for SNMP traps. Trusted
A "trusted host" is a computer that is allowed to use SNMP with AAMS.
0.0.0.0 allows any computer to use SNMP to access the MSAP2000 AAMS.
Specify an IP address to allow only the computer with that IP address to use SNMP
to access the MSAP2000 AAMS.
Click Apply to save your changes to the MSAP2000 AAMS's volatile memory.
The MSAP2000 AAMS loses these changes if it is turned off or loses power, so
use the Config Save link on the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Access Control: Logins
120