Adsl Profile Show Command; Adsl Profile Set Command - ZyXEL Communications Multi-service Access Platform MSAP2000 User Manual

MSAP2000 AAMS User's Guide

26.3.4 ADSL Profile Show Command

Syntax:
adsl profile show [profile]
where
<profile>
This command displays the specified ADSL profile or all ADSL profiles if you do
not specify one.
The following example displays the ADSL DEFVAL profile.
Figure 92
ras> adsl profile show DEFVAL
01. DEFVAL
rate
delay (ms):
margin
margin
0 target margin (db):
6

26.3.5 ADSL Profile Set Command

Syntax:
adsl profile set <profile> <fast|interleave[=<up delay>,<down delay>]> <up max rate> <down max
rate> [<up target margin> <up min margin> <up max margin> <up min rate> <down target
margin> <down min margin> <down max margin> <down min rate>]
where
<profile>
<fast|interleave
[=<up
delay>,<down
delay>]>
<up max rate>
= A profile name.
ADSL Profile Show Command Example
latency mode: interleave
up stream down stream
--------- ----------- max rate
(kbps): 512
(kbps): 64
4
(db): 31
(db):
=
The descriptive name for the profile.
=
The latency mode. With interleave,
you must also define the upstream
and downstream delay (1-255 ms). It
is recommended that you configure
the same delay for both upstream
=
The maximum ADSL upstream transmission rate (64-4096
Kbps).
2048 min
64 latency
4 max
31 min
0
6
175