Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
If your FTP client does not allow you to have a destination filename different than
the source, you will need to rename them as the MSAP2000 AAMS only
recognizes "config-0" and "ras". Be sure you keep unaltered copies of the files for
later use.
The following table is a summary. Please note that the internal filename refers to
the filename on the MSAP2000 AAMS and the external filename refers to the
filename not on the MSAP2000 AAMS, that is, on your computer, local network or
FTP site and so the name (but not the extension) may vary. After uploading new
firmware, use the
correct firmware version.
Table 67
FILE TYPE
Configuration File
Firmware
31.3 Editable Configuration File
The configuration file can be downloaded as a plain-text (ASCII) file.
Edits to the configuration can be made to this file before it is uploaded
again to the MSAP2000 AAMS.
Note: You can change the ".dat" file to a ".txt" file and still upload it to the
MSAP2000 AAMS.
31.3.1 Editable Configuration File Backup
Configure your system, and then use FTP to backup the plain-text configuration
file onto your computer. Do the following to backup the configuration file:
Use an FTP client to connect to the MSAP2000 AAMS.
C:\> ftp <MSAP2000 AAMS IP address>
Enter the User name (just press [ENTER]).
User: [ENTER]
Enter the management password (1234 by default).
Password: 1234
230 Logged in
Use
to transfer the configuration file to the computer. The configuration file on the
get
system
(that you want to backup to the computer) is named
ftp> get config-0
command to confirm that you have uploaded the
sys version
File Name Conventions
INTERNAL NAME
config-0
ras
EXTERNAL NAME
DESCRIPTION
*.dat
This is the configuration filename for the
MSAP2000 AAMS.
*.bin
This is the generic name for the ZyNOS
firmware on the MSAP2000 AAMS.
config-0
238
.
Advertisement
Table of Contents
