MSAP2000 AAMS User's Guide
Switch Commands (continued)
Table 61
COMMAND
showall
27.2 IGMP Filter Commands
Use the IGMP filter commands to define IGMP filter profiles and assign them to
ADSL ports. IGMP filter profiles allow you to control access to IGMP multicast
groups. You can have a service available to a specific IGMP multicast group. You
can configure an IGMP filter profile for an IGMP multicast group that has access to
a service (like a SIP server for example). Then you can assign the IGMP filter
profile to ADSL ports that are allowed to use the service.
27.2.1 IGMP Filter Show Command
Syntax:
switch igmpfilter show [portlist]
where
[portlist]
This command displays which IGMP filter profile an ADSL port(s) is using.
The following example displays which IGMP filter profile ADSL port 9 is using.
Figure 107
ras> switch igmpfilter show 9
port
--------------------------------------
9
27.2.2 IGMP Filter Set Command
Syntax:
switch igmpfilter set [<port>|*] <name>
daisychain
standalone
[nopause]
=
You can specify a single ADSL port <1>, all ADSL
ports <*> or a list of ADSL ports <1,3,5>. You can also
include a range of ports <1,5,6~10>.
IGMP Filter Show Command Example
DESCRIPTION
Sets the device to daisychain mode.
Sets the device to standalone mode.
Displays all of the MSAP2000
AAMS's switch configuration.
profile
DEFVAL
195