Vlan Enable; Vlan Disable; Vlan Show Command - ZyXEL Communications Multi-service Access Platform MSAP2000 User Manual

MSAP2000 AAMS User's Guide
where
<vlanlist>
This command deletes the specified VLAN ID entry from the static VLAN table
The following example deletes entry 2 in the static VLAN table.
Figure 124
ras> switch vlan delete 2

27.9 VLAN Enable

Syntax:
switch vlan <vid>
This command enables the specified VLAN ID in the SVLAN (Static VLAN) table.

27.10 VLAN Disable

Syntax:
switch vlan disable <vid>
This command disables the specified VLAN ID in the SVLAN (Static VLAN)
table. You cannot disable a VLAN if any PVIDs are set to use the VLAN or the
VLAN is the CPU
(management) VLAN.

27.10.1 VLAN Show Command

Syntax
switch vlan show <vlanlist>
where
<vlanlist>
= You can specify a single VID: <1>, all VIDs: <*>, a list of
VIDs: <1,3>, you can also include a range of VIDs:
<1,5,6~
10>.
You cannot delete a VLAN if any PVIDs are set to use
the
VLAN or the VLAN is the CPU (management) VLAN.
VLAN Delete Command Example
= You can specify a single VID: <1>, all VIDs: <*>, a list of
VIDs: <1,3>, you can also include a range of VIDs:
<1,5,6~
10>.
209