Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
27.8.6 VLAN PVID Command
Syntax:
switch vlan pvid <portlist> <pvid>
where
<portlist>
ports
<pvid>
This command sets a default VLAN ID for all untagged packets that come in
through the specified port.
The following example sets the default VID of port 1 to 200.
Figure 118
ras> switch vlan pvid 1 200
27.8.7 VLAN Set Command
Syntax:
switch vlan set <vid> <portlist>:<F<T|U>|X|N> [<portlist>:<F<T|U>|X|N>
...][name]
where
<vid>
<portlist>
ports:
=
You can specify a single port <1>, all ports <*> or a list of
<1,3,enet1>. You can also include a range of ports
<1,5,6~10,enet1,e
net2>.
=
The VLAN ID. Valid parameter range = [1 – 4094].
This must be the VLAN ID of a VLAN that is already
configured. The ports specified in this command
must also be set to the fixed status in the VLAN.
VLAN PVID Command Example
=
The VLAN ID [1 – 4094].
=
You can specify a single port: <1>, all ports: <*>, a list of
<1,3,enet1>, you can also include a range of ports:
<1,5,6~10,enet1,e
net2>.
204
Advertisement
Table of Contents
