Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
25.2.4.4 Trap Community Command
Syntax:
sys snmp trapcommunity <community>
where
<community>
Enter this command with the community to set the password.
25.2.4.5 Trap Destination Set Command
Syntax:
sys snmp trapdst set <ip> [<port>]
where
<ip>
[<port>]
traps.
Use this command specify the IP address (and port number) of the trap server
to which the MSAP2000 AAMS sends SNMP traps. If you leave the trap
destination set to 0.0.0.0 (default), the MSAP2000 AAMS will not send any
SNMP traps.
25.2.4.6 Show SNMP Settings Command
Syntax:
sys snmp show
This command displays the current SNMP get community, set community, trap
community, trusted hosts and trap destination settings.
25.2.5 Server Show Command
Syntax:
ras> sys server show
This command displays which services may be used to access the MSAP2000
AAMS.
An example is shown next.
=
The password sent with each trap to the SNMP manager.
=
The IP address of the trap server.
=
The port number upon which the trap server listens for SNMP
The MSAP2000 AAMS uses the default of 162 if you do not
specify a trap port
159
Advertisement
Table of Contents
