MSAP2000 AAMS User's Guide
where
<portlist>
This command enables the MAC count filter on the specified ADSL port(s).
You can only enable the MAC count filter on ADSL ports that do not have the
MAC filter enabled.
The following example turns on the MAC count filter on ADSL port 4.
Figure 132
ras> switch mac count enable 4
27.12.3 MAC Count Disable Command
Syntax:
switch mac count disable <portlist>
where
<portlist>
This command disables the MAC filtering feature on the specified ADSL port(s).
The following example turns off the MAC count filter on ADSL port 4.
Figure 133
ras> switch mac count disable 4
27.12.4 MAC Count Set Command
Syntax:
switch mac count set <portlist> <count>
=
You can specify a single ADSL port <1>, all ADSL
ports <*> or a list of ADSL ports <1,3,5>. You can also
include a range of ports <1,5,6~10>.
MAC Count Enable Command Example
=
You can specify a single ADSL port <1>, all ADSL
ports <*> or a list of ADSL ports <1,3,5>. You can also
include a range of ports <1,5,6~10>.
MAC Count Disable Command Example
214