Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
The following table describes the labels in this screen.
Table 32
LABEL
Port
MAC
Add
Cancel
afresh. Port
Active
MAC
port. Delete
Apply
MAC Filter
DESCRIPTION
Use this drop-down list box to select an ADSL port for which you wish to configure
MAC filtering.
Type a device's MAC address in hexadecimal notation (xx:xx:xx:xx:xx:xx, where x
is a number from 0 to 9 or a letter from a to f) in this field. The MAC address must
be a valid MAC address. You may specify up to ten MAC addresses per port.
Click Add to save your changes to the MSAP2000 AAMS's volatile memory. The
MSAP2000 AAMS loses these changes if it is turned off or loses power, so use
the Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen
These are the numbers of the ADSL ports.
Select this check box to turn on MAC filtering for a port.
This field lists the MAC addresses that are set for this
Click Delete to remove a MAC address from the list.
Click Apply to save your changes to the MSAP2000 AAMS's volatile memory.
The MSAP2000 AAMS loses these changes if it is turned off or loses power, so
use the Config Save link on the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
99
Advertisement
Table of Contents
