Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
Table 50
LABEL
Gateway IP
Address
Metric
Add
Cancel
View the current static routes on the MSAP2000 AAMS in the summary table at the
bottom of the screen.
Figure 62
The following table describes the labels in the summary table.
Table 51
LABEL
Previous Page
Next Page
Index
Name
Destination
Address
Subnet Mask
Gateway
Address
Metric
Delete
Cancel
Static Routing (continued)
DESCRIPTION
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
AAM that will forward the packet to the destination. The gateway must be a router on
the same segment as your AAM.
The metric represents the "cost" of transmission for routing purposes. IP routing
uses hop count as the measurement of cost, with a minimum of 1 for directly
connected networks. Enter a number that approximates the cost for this link. The
number need not be precise, but it must be between 1 and 15. In practice, 2 or 3
is usually a good number.
Click Add to save the new rule to the AAMS's volatile memory. It then displays in
the summary table at the bottom of the screen. The AAMS loses these changes if
it is turned off or loses power, so use the Config Save link on the navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
Static Routing: Summary Table
Static Routing: Summary Table
DESCRIPTION
Click this to display the preceding page of static route entries.
Click this to display the following page of static route entries.
This field displays the index number of the route.
This field displays the name of this static route.
This field displays the IP network address of the final destination.
This field displays the subnet mask for this destination.
This field displays the IP address of the gateway. The gateway is an immediate
neighbor of your AAM that will forward the packet to the destination.
This field displays the cost of transmission for routing purposes
Select the rule(s) that you want to remove in the Delete column, and then click the
Delete button
Click Cancel to clear the selected checkboxes in the Delete column.
124
Advertisement
Table of Contents
