Ip Commands Summary - ZyXEL Communications Multi-service Access Platform MSAP2000 User Manual

MSAP2000 AAMS User's Guide
For example, use the following command sequence sets the MSAP2000 AAMS to
have 192.168.1.3 as the
IP address, 255.255.255.0 for the subnet mask and 192.168.1.233 for the default
gateway.
ras> ip set 192.168.1.3/24 ras> ip
gateway 192.168.1.233 ras> config
save
Figure 137
The MSAP2000 AAMS leaves the factory with a default (in-band) management IP
address of 192.168.1.1 and a subnet mask of 255.255.255.0, (ff:ff:ff:00 in
hexadecimal notation), and the default gateway set at 192.168.1.254. Make sure
that you configure the IP parameters correctly before you connect an MSAP2000
AAMS to the network, otherwise, you may interrupt services already running.

28.3 IP Commands Summary

The following table lists the
AAMS.
IP Commands
Table 62
COMMAND
ip
show
arp
set
gateway
route
IP Settings and Default Gateway Address
commands you can use with the MSAP2000
ip
show
flush
<ip>[/
netmask]
<gateway ip>
show
set <dst ip>[/
netmask]
<gateway ip>
[metric] <name>
DESCRIPTION
Displays the management IP
address settings.
Displays the device's IP Address
Resolution Protocol status.
Clears the device's IP Address
Resolution Protocol status.
Sets the management IP address
and subnet mask.
Sets the IP address of the
device's default gateway.
Displays the routing table.
Add a routing table entry.
219