Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
This chapter shows you how to configure the static routing function.
19.1 Static Route
Static routes tell the MSAP2000 AAMS how to forward the MSAP2000 AAMS's
own IP traffic when you configure the TCP/IP parameters manually. This is
generally useful for allowing management of the switch from a device with an IP
address on a different subnet from that of the switch's IP address
(remote management).
Click Routing Protocol in the navigation panel and then Static Routing to
display the screen as shown.
Figure 61
The following table describes the related labels you use to create a static route.
Table 50
LABEL
Name
Destination IP
Address
IP Subnet Mask
Static Routing
Static Routing
DESCRIPTION
Type a name to identify this static route. Use up to 31 ASCII characters. Spaces
and tabs are not allowed.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
Enter the subnet mask for this destination
C
H A P T E R
Routing Protocol
123
1 9
Advertisement
Table of Contents
