Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
The
atur information
Unit – Remote), in this case the subscriber's ADSL modem or router, during
negotiation/ provisioning message interchanges. This information can help in
identifying the subscriber's ADSL modem or router.
The vendor ID, vendor version number and product serial number are obtained
from vendor
ID fields (see ITU-T G.994.1) or R-MSGS1 (see T1.413).
29.4.4 ADSL Lineperf Command
Syntax:
statistics adsl lineperf <portlist>
where
<portlist>
This command shows the line performance counters of an ADSL port.
An example is shown next.
Figure 145
ras> statistics adsl lineperf 1
[port 1] Perf since boot up
nfebe-I/nfebe-ni :
ncrc-I/ncrc-ni
nfecc-I/nfecc-ni :
I/nfec-ni
ds/nblks-us:
init-ds/init-us :
n-es-ds/n-es-us :
n-ses-ds/n-ses-us:
n-uas-ds/n-uas-us:
n-lpr-ds/n-lpr-us:
These counters display line performance data that has been accumulated since
the system started. The definitions of near end/far end are relative to the ATU-C
(ADSL Termination Unit-Central Office). Downstream (ds) refers to data from the
ATU-C and upstream (us) refers to data from the ATU-R. "I" stands for interleaved
and "ni" stands for non-interleaved (fast mode).
fields show data acquired from the ATUR (ADSL Termination
=
You can specify a single ADSL port <1>, all ADSL ports
<*> or a list of ADSL ports <1,3,5>. You can also
include a range of ports <1,5,6~10>.
Lineperf Command Example
0/
:
0/
4524/
:
0/
0/
2/
46/
46/
36/
-/
0 (Far End CRC)
0 (Near End CRC)
0 (Far End Corrected FEC) nfec-
0 (Near End Corrected FEC) nblks-
0
2
150
43
36
0
230
Advertisement
Table of Contents
