Log Show Command - ZyXEL Communications Multi-service Access Platform MSAP2000 User Manual

MSAP2000 AAMS User's Guide
where
[none]
<daytime|time|ntp>
<ip>
<utc[<+|->
0100~1200]>
[nosync]
This command sets the MSAP2000 AAMS to use a time server.
The following example sets the MSAP2000 AAMS to use Daytime protocol to
access a time server at IP
address 192.50.77.164 and sets the MSAP2000 AAMS's time zone to UTC.
Figure 86
ras> sys timeserver set daytime 192.50.77.164 utc

25.2.18 Log Show Command

Syntax:
ras> sys log show
This command displays the system error log.
An example is shown next.
= This sets the system to not use a time server.
= The time service protocol.
<daytime>
the switch displays the day, month, year and time with no
time zone adjustment. When you use this format it is
recommended that you use a Daytime timeserver within
your geographical time zone.
<time>
giving the total number of seconds since 1970/1/1 at 0:0:0.
<ntp>
= The IP address of the time server.
The time difference between UTC (Universal Time
=
Coordinated, formerly known as GMT, Greenwich Mean
Time) and your time zone.
=
This sets the system to not synchronize with the
time server immediately after you press [Enter].
Time Server Set Command Example
When you select the Daytime (RFC 867) format,
Time (RFC-868) format displays a 4-byte integer
NTP (RFC-1305) is similar to Time (RFC-868).
164