Igmp Filter Profile Set Command - ZyXEL Communications Multi-service Access Platform MSAP2000 User Manual

MSAP2000 AAMS User's Guide
where
[<port>|*]
ports
<name>
This command sets an ADSL port(s) to use an IGMP filter profile.
The following example sets ADSL port 9 to use the voice IGMP filter profile.
Figure 108
ras> switch igmpfilter set 9 voice

27.2.3 IGMP Filter Profile Set Command

Syntax:
switch igmpfilter profile set <name> <index> <startip> <endip>
where
<name>
<index>
range.
<startip>
multicast IP
<endip>
This command configures an IGMP filter profile.
The following example configures an IGMP filter profile named voice with a
range of multicast IP addresses (index 1) from 224.1.1.10 to 224.1.1.44.
= You can specify a single ADSL port <1> or all ADSL
<
*
>
.
= The name of an IGMP filter profile.
IGMP Filter Set Command Example
= Specify a name to identify the IGMP filter profile (you
cannot change the name of the DEFVAL profile). You
ASCII characters; spaces are not allowed.
= The number (1~16) to identify a multicast IP address
Type the starting multicast IP address for a range of
addresses that you want to belong to the IGMP filter
profile.
Type the ending multicast IP address for a range of IP
addresses that you want to belong to the IGMP filter
profile.
If you want to add a single multicast IP address, enter
it as both the and
startip endip
196
can use up to 31
.