Mac Filter Commands; Mac Filter Show Command - ZyXEL Communications Multi-service Access Platform MSAP2000 User Manual

MSAP2000 AAMS User's Guide
This command shows information about the specified port's VLAN settings.
The following example shows the settings for all VIDs.
Figure 125
ras> switch vlan show *
vid name
---- ---------------- ---------------------------------------------------
1 DEFAULT
enabled
2 test2
enabled
3 test3
enabled
200 test200
enabled

27.11 MAC Filter Commands

Use the MAC filter commands to allow only incoming frames from MAC (Media
Access Control) address(es) that you specify. MAC filter commands are listed
next. You may specify up to ten MAC addresses per port.

27.11.1 MAC Filter Show Command

Syntax:
switch mac filter show [portlist]
where
[portlist]
This command displays the MAC filtering status (V for enabled, - for disabled)
and the fixed source MAC addresses on the specified ADSL port(s) or on all
ADSL ports if no port is specified.
VLAN Show Command Example
F:fixed X:forbidden N:normal
123456789012 12
FFFFFFFFFFFF
FF
UUUUUUUUUUU
U UU
123456789012 12
FXXXXXXXXXXX
NN
U----------- TT
123456789012 12
FXXXXXXXXXXX
NN
U----------- TT
123456789012 12
XXXXXXXXXXXX
FN
------------ UT
= You can specify a single ADSL port <1>, all ADSL
ports <*> or a list of ADSL ports <1,3,5>. You can also
include a range of ports <1,5,6~10>.
210
U:untag T:tag