MSAP2000 AAMS User's Guide
This command removes a configured source MAC address from the ADSL
port that you specify.
The following example removes the source MAC address of 00:a0:c5:12:34:56 from
the MAC
filter for ADSL port 5.
Figure 130
ras> switch mac filter delete 5 00:a0:c5:12:34:56
27.12 MAC Count Commands
Use MAC count commands to limit how many MAC addresses may be dynamically
learned or statically configured on an ADSL port. MAC count commands are
listed next.
27.12.1 MAC Count Show Command
Syntax:
switch mac count show [portlist]
where
[portlist]
This command displays the MAC count settings on the specified ADSL port(s) or
on all
ADSL ports if no port is specified.
The following example displays the MAC count settings for ADSL port 4.
Figure 131
ras> switch mac count show 4
port status count
---- ------ -----
4
27.12.2 MAC Count Enable Command
Syntax:
switch mac count enable <portlist>
MAC Filter Delete Command Example
=
You can specify a single ADSL port <1>, all ADSL
ports <*> or a list of ADSL ports <1,3,5>. You can also
include a range of ports <1,5,6~10>.
MAC Count Show Command Example
V
1024
213