Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
The following table describes the labels in this screen.
Table 52
LABEL
Syslog/ Event Log
IP Ping
Loopback Test
LDM Test
21.2 Log Format
The common format of the system logs is:
message>
Table 53
LABEL
<item no>
<time>
<process>
<type>
<log message>
Diagnostic
DESCRIPTION
Click Display to display a log of events in the multi-line text box. Click
Clear to empty the text box and reset the syslog entry.
Type the IP address of a device that you want to ping in order to test a connection.
In the field to the right specify the number of times that you want to ping the IP
address. Click Ping to have the MSAP2000 AAMS ping the IP address (in the
field to the left).
Select a port number from the Port drop-down list box and enter a VPI/VCI to
specify a PVC. Click OAM F5 Loopback to perform an OAMF5 loopback test on
the specified DSL port. An Operational, Administration and Maintenance Function
5 test is used to test the connection between two DSL devices. First, the DSL
devices establish a virtual circuit. Then the local device sends an ATM F5 cell to
be returned by the remote DSL device (both DSL devices must support ATM F5 in
order to use this test). The results ("Passed" or "Failed") display in the multi-line
text box.
Select a port number from the Port drop-down list box and click Set LDM Port to
have the MSAP2000 AAMS perform line diagnostics on the specified port. The
ADSL port must be set to ADSL2 or ADSL2+ ADSL operational mode and have a
connection. It takes about one minute for the line diagnostics to finish. The screen
displays a message confirming upon which ADSL port line diagnostics will be
performed. Click Get LDM Data to display the line diagnostics results after using
the Set LDM Port button on an ADSL port. Use the line diagnostics results to
analyze problems with the physical ADSL line.
Note: Wait at least one minute after using Set LDM Port
before using Get LDM Data.
Log Format
DESCRIPTION
This is the index number of the log entry.
This is the time and date when the log was created.
This is the process that created the log.
This identifies what kind of log it is. "INFO" identifies an information log.
"WARN" identifies a warning log.
This is the log's detailed information (see
<item no> <time> <process> <type> <log
130
Table 54 on page
159).
Advertisement
Table of Contents
